Birds & lights.
Connect each board separately. Control either cue, or keep both connected.
Switching panels keeps both connections active. Use Stop all to stop both boards.
Connect Birds
Nano ESP32Disconnect before changing connection type.
Checking browser support…
Install Birds firmware V2.7 on this board before connecting. Outputs start off.
Bird controls
Outputs offConnect the Birds board to use these controls.
Click a servo to start. Travel settings are applied automatically, and only the selected servo(s) are enabled. A click may first move to the rest position. Test with the servos unloaded on the table.
Not repeating.
Repeat uses the travel settings below, one out-and-back cycle at a time. The cycle count comes from board status; it does not measure physical rotation. Use Stop birds to end a repeat before choosing another servo. Switching away from this browser page stops motion; returning never restarts it.
Adjust position One step per click; no continuous sweep
No device status yet
These buttons directly move the selected servo. Degrees are a reference, not a measurement. Recording a position updates the draft for your next movement click. Commands outside the limits are rejected.
Travel settings
Unapplied draftOptional: edit while idle. Your next movement click applies these settings automatically. Sliders and Apply alone do not start motion. Reference scale: 90° = 1500 μs; 0–180° maps to 500–2500 μs. This is not a measured angle or a verified travel range for this servo.
Profiles stay in this browser on this device; the control code is never saved. Loading changes the draft for your next movement click. Restarting the board restores the small-motion defaults.
Connect Lights
ESP32-S3Disconnect before changing connection type.
Checking browser support…
Install Lights firmware V2.7 on this board before connecting. Outputs start off.
LED controls
Lights offLeft LED: GPIO4. Right LED: GPIO5. Use a separate series resistor for each LED. Test with the glasses on a table.
Choose a pattern. It applies to enabled LEDs when you turn a light on. Editing settings alone does not change the output.
Left and Right toggle independently: click once for on, again for off. Both turns both on, or turns both off when both are enabled. On means enabled, including the dark phase of a blink.
Keep this page visible and the device connected. Steady light has no 60-second cutoff. Disconnecting or a communication timeout turns the lights off.